TankMate
Search…
Reconnect - v2 Wi-Fi Level Sensor
The app has two methods to reconnect a v2 sensor to a Wi-Fi network. The default mode is called BlueConnect, which uses a temporary bluetooth connection to send network credentials to the sensor.
First, check that your sensor is not already connected! Press the RESET button once (short press) and watch the status LED. If you see a solid BLUE (CYAN) colour for 5-10 seconds, the unit is already connected to a Wi-Fi network.

Reconnect a sensor using BlueConnect

  • In the TankMate app, go to Settings > Sensor / Tank Settings > Edit Network Settings
*Note: existing TankMate units (sold prior to Feb 2022) may be running an older firmware version. Skip ahead to the "v17 Firmware" section for details on how to access BlueConnect mode - the status LED modes are different!
  • Put the sensor into BlueConnect mode: on the side of the sender unit - hold the RESET button for 6-8 seconds then release.
  • The status LED will blink slowly - dark blue - when in this mode
  • The unit will go to sleep to conserve power after 3 mins. Click RESET again to wake it up.
  • Follow the prompts in the app to scan for the sensor. Ensure the status light on the sensor is still blinking. Select the TankMate device, and proceed to the network SSID and password page

* v17 Firmware or Earlier

Some TankMate units (sold prior to Feb 2022) will be running an older firmware version. To access BlueConnect mode:
  • Hold the RESET button for 12+ seconds then release.
  • The status LED will blink a pink / purple colour when in BlueConnect mode
  • The unit will go to sleep to conserve power after 3 mins. Click RESET again to wake it up
  • Follow the prompts in the app to scan for the sensor. Ensure the status light on the sensor is still blinking. Select the TankMate device, and proceed to the network SSID and password page