Set Up a New R3 Sensor
Installation guide for R3 sensors
See the Quick Start Guide pdf

Add a New Sensor

Using BlueConnect

  • In the TankMate app, select R3 - on the "Add new sensor" screen
  • Scan the QR code - located under the base of the sensor
  • Ensure the sensor is in BlueConnect mode - the status LED will blink dark blue (slowly) - when in this mode
The sensor will go to sleep after 3 minutes of inactivity. To get it back into BluConnect mode, press the READ / RESET button once
  • Follow the prompts in the app to scan and connect to the sensor
  • A sensor ID will be displayed under the button. Select this to continue
On the next screen:
  • select the correct WiFi network and enter the password
  • Ensure the sensor is still blinking dark blue
  • Press "CONFIRM" to send your network details to the sensor
The sensor should be within a few metres of your mobile phone - to ensure the temporary bluetooth connection is in range
  • A success message should be displayed in the app - to indicate a successful connection
For toubleshooting issues with BluConnect - see here